OEG EcoComfort - Page 36

36 EcoComfort
. Operating modesSetting the operating mode
In case less than  operating periods are required, it is not necessary
to change the surplus periods regarding the factory setting (they can
also be set to the same time).
If a user, for example, only needs the operating period from : to
:, the setting is as follows:
Time period Hour Minute
F  
F  
F  
F  
F  
F  
By default, the time setting is ““.
If you want to change the factory setting of unused periods, you also
have to do that for all the following. If you, for example, only need
one time period and you use F and F for that and you change F
then, you also have to set F, F and F to the same values. But you
may also leave the unused periods F to F set to ““.
High-efficiency drinking water circulation pump
GB