5
Operating Instructions and Parts Manual OEM24893/OEM24894
5/20
2020 OEMTOOLS
®
24"/30" OUTDOOR OSCILLATING
WALL MOUNT FAN
ADJUSTING FAN ANGLE
1. While supporting the weight of the fan, loosen the
Handwheel and remove the bolt. If the weight of the
fan is not supported, the fan will not fall to the ground;
instead, it will pivot uncontrollably toward the operator.
2. Allow the fan to pivot forward to the second angled
adjustment, then replace the bolt and use the
Handwheel to fasten securely.
OPERATION INSTRUCTIONS
1. Mount in accordance with provided assembly
instructions.
2. Plug the fan into a grounded 120V/60 Hz outlet.
3. Test GFCI (Ground Fault Circuit Interrupter) before
each use.
a. Press the RESET button (b). Indicator (a) should
turn red.
b. Press the TEST button (c). Indicator (a) should
turn off.
c. Press the RESET button (b) again before
attempting to use.
d. DO NOT ATTEMPT TO USE IF GFCI TEST
FAILS. Call customer service for assistance.
4. Adjust to the desired speed by pulling the chain (e):
0 – OFF
1 – Low
2 – Medium
3 – High
NOTE: To extend the life of the fan motor, allow the fan to run
for at least one minute at each setting before moving to the
next setting.
5. Press the oscillation knob (d) for oscillating function.
Pull the oscillation knob (d) to lock the fan in the
desired position.
6. Turn the fan to OFF before unplugging from the
electrical outlet.
STORAGE
Store the Outdoor Oscillating Fan in an upright position
and in a clean, dry area. DO NOT store near flammable
items or open flames.
PRODUCT MAINTENANCE
WARNING: Unplug the fan before performing product
maintenance.
WARNING: DO NOT use water to clean the fan
motor. While the product is water resistant, excessive
water may lead to product malfunction.
Use a vacuum cleaner to remove dust from the protective
fan guard and blades. If desired, remove the front
protective fan guard to access the fan blades. Ensure the
protective guard is securely reattached prior to use. A
damp cloth may be used to wipe the Front Guard.
DISPOSAL
At the end of the useful life of the OEMTOOLS
®
24"/30"
Outdoor Oscillating Wall Mount Fan, dispose of the
components in accordance with all federal, state, and
local regulations.
To Next Page
Loading...
