Need help?Do you have a question about the OHAUS SP202 and is the answer not in the manual?
Details conformity with EEC directives and relevant standards for electrical safety and EMC.
Ohaus Corporation's ISO 9001 certification details and audit process.
FCC regulations for digital devices and measures to mitigate interference.
Compliance with Canadian ICES-003 and AS/NZS standards.
Critical safety guidelines to follow during operation and handling of the balance.
Steps for releasing the shipping lock and installing the platform.
Guidance on selecting the location and ensuring the balance is properly leveled.
Instructions for installing batteries and connecting the AC adapter.
Identifies and briefly describes the balance's main controls and display elements.
Lists all buttons (Feet, PRINT/Unit, ON/ZERO/Off, Lockswitch, etc.) and their specific roles.
Describes the 7-segment LCD, units (g, kg, oz, etc.), and stability/negative sign indicators.
Explains turning on/off, zeroing, and entering the menu modes.
Describes print commands, unit scrolling, and menu bypassing.
Defines symbols indicating press duration (1, 3, 5 seconds) and display scrolling.
Step-by-step guide for turning the balance on and off.
Visual representation of Cal, Setup, Units, and End menu options and their sub-options.
Step-by-step process to enter the four primary menu categories.
Explains how to confirm or skip individual settings within a menu.
Steps to access and adjust settings within the SETUP menu.
Instructions for enabling the Display Hold and Totalize modes.
Procedure to exit the SETUP menu and return to weighing mode.
Steps to enable/disable various units of measure and parts counting.
Details standard and enhanced parts counting methods.
Step-by-step guide for performing span calibration using zero and a calibration weight.
Final steps for span calibration, including removing the weight.
How to perform linearity calibration using three calibration points.
Instructions for placing a sample and obtaining a stable weight reading.
Steps for zeroing the container weight before adding contents.
Procedure for standard parts counting, including clearing average part weight.
Method for enhanced parts counting, allowing additional parts.
Steps to establish a reference weight and view other loads as percentages.
Instructions for counting different sets of parts after initial setup.
Process to update the reference weight for percent weighing or display hold.
How to capture and store the highest stable weight value.
Procedure to disable the Display Hold feature.
Steps for accumulating multiple weights, with display indicators.
How to erase accumulated weight data from the totalize function.
Steps to activate LFT settings for regulated trade.
Details the function of the lock switch for protecting settings or menus.
Procedure for sealing the balance after official approval.
Recommendations for keeping the balance clean and in good working order.
Table of symptoms, probable causes, and remedies for balance malfunctions.
Explanations and potential solutions for various error messages.
Provides part numbers for kits, cases, printers, scoops, and calibration masses.
Table detailing capacity, calibration masses, readability, and weighing modes per model.
Detailed breakdown of capacity and readability for each unit of measure.
Details the warranty period, repair options, and conditions that void the warranty.
To Next Page
General
