How to fix OHAUS Scales that will not turn on?
If your OHAUS Scales won't turn on, the issue might be due to a lack of power. Check the power supply to ensure it is properly connected and functioning.
What to do if OHAUS Scout SPX1202 Scales show 'Err 8.3'?
If your OHAUS Scales display the error message 'Err 8.3', it means the weight on the scale exceeds its rated capacity. To resolve this, remove the excess weight from the scale.
Why are my OHAUS Scout SPX1202 Scales showing poor accuracy?
If your OHAUS Scales are displaying 'Poor accuracy', it could be due to improper calibration. You should recalibrate the balance. Also, an unstable environment can cause this issue, so place the balance on a stable surface.
What does 'Err 8.4' mean on OHAUS Scout SPX1202?
If your OHAUS Scales display 'Err 8.4', this indicates an underload condition, meaning the pan is removed. Make sure the pan is properly in place.
What to do if OHAUS Scales display 'CAL E'?
If your OHAUS Scales are showing 'CAL E', it means the calibration process has failed. Ensure you carefully follow the calibration process.
What does 'Err 8.1' mean on OHAUS Scout SPX1202 Scales?
If your OHAUS Scales display the error 'Err 8.1', it means the weight exceeds the power on zero range. Make sure the weight is within the allowable range.
What does error 'Err 8.2' mean on OHAUS Scout SPX1202?
If your OHAUS Scales display 'Err 8.2', it means the weight is below the power on zero range. Adjust the weight to meet the zero range requirements.
What does 'Err 8.5' mean on OHAUS Scales?
If your OHAUS Scales display 'Err 8.5', it indicates that the tare is out of range. Recheck the tare settings.
What does 'Err 8.6' mean on OHAUS Scout SPX1202, and how do I fix it?
If your OHAUS Scales display 'Err 8.6', the displayed value exceeds 999999, which can happen in Totalization mode. Reset the totalization mode to resolve this.
What does 'ref.err' mean on OHAUS Scales?
If your OHAUS Scales display 'ref.err', it means there is a parts counting or percentage error because the sample weight is less than 1d. Use a sample weight that is 1d or greater.
General| Capacity | 1200 g |
|---|---|
| Readability | 0.01 g |
| Display | LCD with backlight |
| Calibration | External Calibration |
| Linearity | ± 0.02 g |
| Repeatability | ± 0.01 g |
| Interface | RS232 |
| Auto-Off | Yes |
| Overload Protection | Yes |
| Power Supply | AC adapter (included) or 4 AA batteries (optional) |
| Stabilization Time | 1.5 sec |
| Operating Temperature Range | 10°C to 40°C |
| Weighing Units | g, oz |
To Next Page