Ohmic instruments UPM-DT-10 User Manual

9
The UPM-DT Series provides date and time data which
can be viewed on a computer or printed out on an exter-
nal printer. When you put your new instrument into op-
eration for the first time, you should enter the current
date and time. These settings are retained as long as
the balance remains connected to a power source.
Date is a feature which enables the balance to be set to
a U.S. date standard or European. U.S. standard has
the month, day and year each separated by a / in the
printout. The European date standard has the day,
month and year each separated by a period. The default
setting is U.S. standard.
Procedure:
1. Press the Setup button; CAL is displayed.
2. Press  or  button and select Date from the menu.
3. Press Enter button; TYPE is displayed.
4. Press Enter button; SET M d y, d M y, y M d, M y d,
y d M, or d y M is displayed.
5. Press  or  button and select type of date.
6. Press Enter button; SAVED is displayed, then SET is
displayed.
7. Press Enter button; first digit of date will flash.
8. Using  or  buttons, enter the correct date.
9. When the correct date is entered, press Enter but-
ton.
10. SAVED is displayed momentarily, and EXIT appears.
11. Press Enter button; balance returns to weighing
mode.
Time is a feature which enables the balance to be set to
the current time in either U.S. standards (12 hour peri-
ods) or European/military standards (24 hour periods).
The default setting is U.S. standards.
Procedure:
1. Press the Setup button; CAL is displayed.
2. Press  or  button and select Time from the menu.
3. Press Enter button; TYPE is displayed.
4. Press Enter button; TYPE 12 hr is displayed.
5. Press  or  button and select 12 hr or 24 hr.
6. Press Enter button; SAVED is displayed, then SET is
displayed.
7. Press Enter button; SET with time will flash.
8. Using  or  buttons, enter the correct time.
9. When the correct time is entered, press Enter button.
10. SAVED is displayed momentarily, and EXIT appears.
11. Press Enter button; balance returns to weighing
mode.
Adjustments up to ± 60 seconds a month can be made to
the balance’s internal clock. Repeat the first seven
steps, ADJUST is displayed. Using the arrow buttons,
enter time correction and press Enter button.
SETTING DATE AND TIME

Ohmic instruments UPM-DT-10 Specifications

General

Brand	Ohmic instruments
Model	UPM-DT-10
Category	Measuring Instruments
Language	English