What to do if the escaper operation does not stop though a screw is at the pick up site of my OHTAKE Industrial Electrical machine?
If the escaper operation does not stop even when a screw is at the pick-up site, readjust the voltage of the sensor.
Why does the escaper rotate in the wrong direction in my OHTAKE Industrial Electrical machine?
If the escaper rotates in the wrong direction, check whether it has hit the holding plate while the screw rotates. If the escaper or escaper guide is damaged or worn off, replacement is recommended.
What to do if a screw has fallen into the machine OHTAKE OM-26M?
Take the cover off and remove the screw.
Explains safety alert symbols, signal words, and their meanings for safe operation.
Essential safety warnings regarding electrical shock, fire, and damage from improper use.
Important cautions for safe operation, preventing damage, and maintaining machine integrity.
Diagnosing and correcting issues when the machine fails to start or operate.
Identifying and resolving causes for screws not being transported or picked up correctly.
Troubleshooting steps for when screws fall into the rail groove or between parts.
Addressing problems with screw transport on the rail, including vibration and dirt issues.
Diagnosing why no screws are delivered to the pick up spot.
Troubleshooting sudden shutdowns, including overload protection and caught screws.
General| Model | OM-26M |
|---|---|
| Insulation Resistance | 100 MΩ min. at 500VDC |
| Operating Temperature | +85°C |
| Contact Material | Ag Alloy |
| Mechanical Life | 10, 000, 000 operations |
| Electrical Life | 100, 000 operations at rated load |
To Next Page