Oilon Junior Pro 1 LJ10

Need help?

Do you have a question about the Oilon Junior Pro 1 LJ10 and is the answer not in the manual?

Summary

Burner Technical Data

Parts List

Burner Installation

Electric Connections

Connecting the Burner to the Mains

Connecting the Burner to Oil Supply Line

Fuel System

Oil Pipes

Oil Pumps

Burner Operation

Burner Operation Principle

Burner Adjustment

Capacity Regulation

Method for adjusting the burner's heat output capacity.

Nozzle Selection

Guide for choosing the correct nozzle size based on boiler requirements.

Oil Pump Pressure Regulation

How to set and adjust the oil pump's operating pressure.

Calculation of Burner Capacity

Nozzle and Ignition Electrode Settings

Change of nozzle

Adjusting the Air Velocity in the Combustion Head J50, LJ50

Adjusting the Distance and Centrality of the Nozzle

Combustion Air Adjustment

Steps to adjust the air intake for efficient combustion.

Control Unit BHO 64.A;LOA 24.173 A27

Time Sequence Diagram (Control Program)

Control Functions in the Event of Faults

How the control unit handles and responds to various fault conditions.

Maintenance

Burner maintenance

Fault Conditions and Procedures

Motor

Troubleshooting steps when the burner motor fails to start.

Ignition failure

Diagnosing and resolving issues with ignition.

No flame establishment

Steps to take when the burner starts but fails to establish a flame.

Oil pump

Common problems and solutions related to the oil pump.

Premature flame formation

Troubleshooting lock-outs caused by flame during pre-purge.

Flame monitoring fault

Addressing lock-outs due to flame detection errors.