35
Repair and Replacement Procedures
WARNING!
ALWAYS ensure the main power supply is first locked out and the system depressurized before any
service is performed on this system. NEVER connect or disconnect lines, change filter elements, or
undertake any service work when this system is running or energized. SEVERE injury or death may
occur.
The Tank Isolation Valves (located on the underside of each tank) must be in the open position when
operating the system and in the closed position when servicing the system.
The major components of the system were designed to be replaceable. Before attempting any repairs or replacement,
contact OilSafe in the eventyour part is covered by warranty.
You may contact OS as follows:
930 Whitmore Drive (972)771-1000
Rockwall, TX 75087 sales@whitmores.com
www.oilsafe.com
Do not disassemble any part of the system without authorization from OilSafe. Failure to
receive this authorization will void your product warranty.
The following parts of your system are replaceable. Contact your supplier for ordering
information.
To Next Page
Loading...