☞
☞
☞
1-7
Press the UP ( ) or DOWN ( ) buttons to select
the correct hours and press OK button ( ).
Press the UP ( ) or DOWN ( ) buttons to select
the correct minutes and press OK button ( ).
Then press the UP ( ) or DOWN ( ) button to
select the correct day and press OK ( ) button.
First time power is connected the clock and day will be flashing and must be set. If you need to
adjust the time of the thermostat at a later date, insert a pin into the hole marked (see fig. 1)
for setting of time and day. Adjustment should be made for change in summer and winter time.
p. 35
Display
Setting the room controller into operation
AREA SETUP - see page 40
Type WLCT
To Next Page
Loading...
Need help?
General
