Oki 320 - Reset Top of Form to Factory Default; Printer off; Printer on

|
User’s Guide: English 45
Reset Top of Form to Factory Default
!
If you turn the platen knob when the printer is turned
on, you will cause the Top of Form to mis-align. Always
turn the printer off before turning the platen knob!
!
The factory default setting for the Top of Form (where
the printing should begin) is one inch down from the top
of the page.
There are two ways to reset the Top of Form to the factory
default.
• with the printer ON.
• with the printer OFF.
Printer ON
1 With the printer ON, and paper parked (out of the printer)
Press QUIET / TOF.
Printer OFF
1 With the printer OFF, and no paper installed,
Press and hold PARK + QUIET/TOF while turning on the
printer.