54 Microline 390/391 Turbo
|
Changing Paper Paths
Continuous-forms to single-sheet feed
1 Tear off any printed pages.
2 Press PARK.
3 Raise the paper separator to the single-sheet feed position.
4 Place the wire feed guide in the paper separator.
5 Move the paper lever to the position marked “TOP.”
The paper lever is towards the back of the printer.
6 Place a sheet of paper in the paper separator.
32T-12.eps
Single-sheet feed to continuous forms
1 Press FF/LOAD to remove the single-sheet paper.
2 Lower the paper separator into the continuous-forms
position. Swing the wire feed guide over onto the pull-up
roller.
3 Move the paper lever to the appropriate position.
For rear feed (1), the paper lever is towards the front of the
printer.
For bottom feed, (2), the paper lever is in the center
position.
4 If necessary, load continuous-form paper.
5 Press FF/LOAD.
32T-11.eps and Turbo-1.eps
2
1
To Next Page
Loading...
Need help?
General
