72 Microline 390/391 Turbo
|
Menu Settings Table (Continued)
For a complete explanation of each menu item, refer to “Using Your Printer, Menu Mode, Explanations of Menu Items.”
The table below shows the items which may appear in the menu. Settings which are engaged at the factory (defaults) are set in
bold italic. Some groups or entries will only appear when a specific emulation is engaged, as noted.
Group Item Settings (Defaults are set in bold italic)
Rear Feed Line Spacing 6 LPI, 8 LPI
Form Tear-Off Off, 500 ms, 1 sec, 2 sec
Skip Over Perforation No, Yes
Page Width (wide model only) 13.6", 8"
Page Length 11", 11-2/3", 12", 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5"
Bottom Feed Line Spacing 6 LPI, 8 LPI
Form Tear-Off Off, 500 ms, 1 sec, 2 sec
Skip Over Perforation No, Yes
Page Width (wide model only) 13.6", 8"
Page Length 11", 11-2/3", 12", 14", 17", 3", 3.5", 4", 5.5", 6", 7", 8", 8.5"
To Next Page
Loading...
Need help?
General
