D
donna04Aug 30, 2025
What causes fuzzy print on Oki B4400 Printer?
- EElizabeth WatsonAug 31, 2025
Fuzzy print on your Oki Printer can be caused by a dirty LED array. Clean the LED array to resolve this issue.
To Next PageTo Next PageWhat causes fuzzy print on Oki B4400 Printer?
Fuzzy print on your Oki Printer can be caused by a dirty LED array. Clean the LED array to resolve this issue.
Why is my Oki B4400 Printer printing entirely faintly?
If your Oki Printer is printing entire pages faintly, it's likely that the toner cartridge is empty or running low. Pages tend to get fainter as the toner is used up, so install a new toner cartridge.
Why is my Oki Printer printing light or blurred pages?
If your Oki Printer's output is light or blurred, it could be due to several reasons: the toner may be low, so replace the toner cartridge. Ensure you are using paper meant for laser printers. Also, the LED array might be dirty, so clean the LED array.
What causes smeared or blotched print on Oki B4400 Printer?
Smeared or blotched prints from your Oki Printer can be caused by dirty rollers, toner dropped inside the printer, or an image drum issue. Try replacing the image drum and toner. Contact service.
Why is my Oki B4400 printing faded print?
If your Oki Printer's print is faded, it may be because the toner cartridge is not correctly installed or the toner is low. Try installing the toner cartridge correctly or replacing it with a new one.
What to do if my Oki B4400 Printer prints blank sheets?
If your Oki Printer is printing blank sheets, it could be due to the image drum cartridge not being properly installed. Try reinstalling the image drum cartridge. Another possible cause is an empty or missing toner cartridge, so install a new toner cartridge.
How to resolve feed jam or exit jam on Oki B4400?
To resolve a feed or exit jam on your Oki Printer, remove the tray and clear any misfed sheets. Open the top cover, carefully lift out the image drum (with the toner cartridge), and remove any jammed sheets from the paper path. Re-install the image drum with the toner cartridge, close the top cover, and latch it closed. The printer will warm up and start printing. If the paper edge protrudes from the exit, reinstall the image drum, close the top cover, and switch the printer on. Remove the jammed paper when the exit roller rotates. If you still can't remove the paper, contact a service representative.
General| Print Technology | LED |
|---|---|
| First Page Out Time | 5 seconds |
| Processor | 200 MHz |
| Paper Capacity | 250 sheets |
| Connectivity | Parallel, USB |
| Printer Languages | PCL6, PCL5e, PostScript 3 |
| Maximum Paper Size | A4 |
| Interface | Parallel, USB |
| Operating Systems Supported | Windows 2000, XP, Vista |
