Why is printed page light or blurred with Oki B4200 Printer?
If a printed page is light or blurred when using your Oki Printer, it could be due to several reasons:* Low toner: Replace the toner cartridge.* Incorrect paper: Use recommended paper meant for laser printers.* Dirty LED array: Clean the LED array.
How to resolve feed jam or exit jam on Oki B4200?
To resolve a FEED JAM or EXIT JAM on your Oki Printer:1. Remove the tray and clear any misfed sheets.2. Open the top cover.3. Carefully lift out the image drum, complete with the toner cartridge, being careful not to touch or scratch the green drum surface.4. Remove any jammed sheets from the paper path.5. Re-install the image drum complete with toner cartridge, ensuring that it correctly locates into the slots on each side of the printer.6. Close the top cover and press down to latch it closed.The printer will warm up and commence printing when ready. The page lost through the jam will normally be reprinted.
What to do if my Oki B4200 Printer prints blank sheets?
If your Oki Printer is printing blank sheets, it could be due to the image drum cartridge not being properly installed. Try reinstalling the image drum cartridge. Alternatively, the toner cartridge may be empty or missing. If so, install a new toner cartridge.
Why does my Oki B4200 Printer have faded print?
Faded print on your Oki Printer can occur if the toner cartridge is not correctly installed or if the toner is low. To resolve this, correctly install the toner cartridge or replace it with a new one.
Why is my Oki B4200 printing garbage?
If your Oki Printer is printing garbage, it may be due to an incorrect cable configuration. Check the cable configuration, continuity, and length.
What causes odours from Oki B4200 Printer?
Odors from your Oki Printer are often due to gases given off by forms or adhesives passing through the hot fusing unit. Make sure the forms you use can withstand heating, and provide adequate ventilation.
What causes the size of the top margin to increase with each page printed on Oki Printer?
If the size of the top margin increases with each page printed on your Oki Printer, it's likely due to creeping text. This occurs when the number of lines per page in the software is not equal to the number of lines per page of the printer. Many software packages assume 66 lines per page, but your printer’s default is 64. Adjust the software accordingly, or set LINES Per PAGE in the soft control panel to equal the lines per page in your software.
Why does my Oki B4200 have vertical white streaking or faint areas on the page?
Vertical white streaking or faint areas on pages printed by your Oki Printer can occur if the toner is low and does not distribute properly, or if the drum is worn out. Replace the toner cartridge. Check the drum and replace it if necessary.
What causes fuzzy print on Oki Printer?
Fuzzy print on your Oki Printer is often caused by a dirty LED array. Clean the LED array to resolve this issue.
Why is my Oki B4200 Printer printing smeared or blotched prints?
Smeared or blotched prints from your Oki Printer can be caused by dirty rollers, toner dropped inside the printer, or an image drum problem. Replace the image drum and toner.
To Next Page
General
