IV - 43
Section 4 - Chapter 6 - Telnet Configuration
OKI OkiLAN 6020e User’s Guide
TCP/IP
Chapter 6
Telnet Configuration
Overview
The OkiLAN 6020e Configuration utility (telnet)
provides system, network and printer status information
and allows you to change the configuration of your
OkiLAN 6020e.
Note: The configuration of your OkiLAN 6020e is
password protected. Only authorized users can
alter the configuration.
Running a Telnet Session
1. To run the configuration utility, type the following:
telnet <OkiLAN 6020e_name>
2. Replace OkiLAN 6020e_name with the IP address or
the host name assigned to the OkiLAN 6020e you
want to configure.
A screen will appear displaying an introductory
message. When prompted for a password, enter
OkiLAN. The password will not be echoed.
3. When you are finished typing your password, press
Enter. For password verification, you will then be
asked to enter your password again.
Each time you use the utility, you will be asked to
enter your password. If you fail to enter the
password correctly in three attempts, your
connection with the OkiLAN 6020e will be closed.
4. Once your password is entered and accepted, a list of
options will display. An explanation of each option
follows.
To Next Page
Loading...
Need help?
General
