IV - 21
Section 4 - Chapter 3 - TCP/IP Configuration and Printing
OKI OkiLAN 6020e User’s Guide
TCP/IP
Example: The following example prints a PostScript
file called chart.ps to the OkiLAN 6020e printer Port 1
using FTP.
$ ftp OkiLAN 6020e_name<Enter>
Connected to OkiLAN 6020e_name.
220 ESI-2810 Version 3.0 ready.
Name (OkiLAN 6020e_name:anyone):<Enter>
230 User logged in.
ftp> binary<Enter>
200 Type set to I.
ftp> put chart.ps MPX1<Enter>
local: chart.ps remote: MPX1
200 PORT command successful.
150 Opening BINARY mode data connection for
MPX1.
226 Transfer complete.
4549 bytes sent in 0 seconds (4.4 Kbytes/s)
ftp> bye<Enter>
221 Goodbye.<Enter>
$
Timeout Checking
If timeout checking is enabled on the OkiLAN 6020e,
the OkiLAN 6020e will close any connection that stays
idle for more than five minutes. For example, if you
open an FTP connection to the OkiLAN 6020e and
walk away from your computer for more than five
minutes, the FTP connection will be closed. You can
reestablish a connection to the OkiLAN 6020e with the
OPEN command.
To Next Page
Loading...
Need help?
General
