Troubleshooting > 50
6. Repeat this removal procedure for each of the remaining image drum units. Cover
the image drum units to protect them from direct light.
7. Look into the printer to check whether any sheets of paper are visible on any part of
the belt unit.
8. Remove any sheets of paper as follows:
> To remove a sheet with its leading edge at the front of the belt, carefully lift the
sheet from the belt and pull it forwards into the internal drum cavity and
withdraw the sheet.
> To remove a sheet from the central area of the belt, carefully separate the sheet
from the belt surface and withdraw the sheet.
CAUTION!
Do not use any sharp or abrasive objects to separate sheets from the
belt. This may damage the belt surface.
2
1
To Next Page
Loading...
