44951501TH Rev.2
2-13
Oki Data CONFIDENTIAL
2. DESCRIPTION OF OPERATION
Error checking methods and remedies
The color registration correction test function among the other self-diagnostic functions is
employed to check errors. (Section 5.3.2.6)
Remedies for different errors
•CALIBRATION(LorR),DYNAMICRANGE(LorR)
Check 1: If the above indication appears, check the connected state of the sensor
cable.
If the connected state is found abnormal, restore it to the normal state.
Check 2: Check to see whether the sensor surface is stained with toner, paper dust
or any other foreign matter.
If it is found stained, wipe it clean.
Check 3: Check to see whether the sensor shutter opens and closes normally, by
the MOTOR & CLUTCH TEST of the self-diagnostic function. If the shutter
operates imperfectly, replace the shutter unit.
If no problem was found by the checks 1 through 3, there is a problem with
the circuit.
Replace each of the color registration sensor board, the CU/PU board and
the connector cable one by one and check that no error will occur again.
•BELTREFLXERR
Check 4: If this indication appears, check the cleaned state for the toner remaining
on the belt surface, in addition to making the above checks 1, 2 and 3.
Take out the belt unit, turn the drive gear located on the left rear side, and
ensure that the belt surface has been cleaned thoroughly.
If cleaning is not achieved perfectly and there still remains toner on the belt
surface after the drive gear has been turned, replace the belt unit.
•(YorMorC)LEFT,(YorMorC)RIGHT,(YorMorC)HORIZONTAL
Check5:Iftheaboveindicationappears,checktoseewhethertonerofNG-issuing
color is running short.
Replace a toner cartridge, as needed.
To Next Page
Loading...
Need help?
General
