Menu functions - C821 and C830 > 68
Storage setup
Power setup
Language setup
Erase HDD Execute Deletion of all data stored in the hard disk. DoD
5220.22-M sanitizing formula is used for clearing the
disk. The machine will restart after changing setup. The
following message appears after pressing the Enter
switch.
Are You Sure?
Yes
No
If NO is selected, you will be returned to the source
menu
If Yes is selected the procedure for clearing disk will
start immediately after the machine reboots.
If the Cancel button is held down during erasing, the
following confirmation messages will appear to
discontinue processing.
Do You Wish to Cancel?
Yes
No
If NO is selected, the procedure will continue. If YES is
selected, the procedure will discontinue.
Enable initialization No
Yes
Prevents a setting change accompanying initialization of
Block Device (HDD,FLASH).
ITEM SETTINGS EXPLANATION
Enable initialisation Yes/No
ITEM SETTINGS EXPLANATION
Peak Power Control Normal/Low Sets peak Power control level.
Power Save Enable
Disable
Sets Enable/Disable of Power Save Mode.
USB Host Power Off/On Sets power supply for USB-HOST of the whole power
save mode.
When Off, suppress power supply.
When On, do normal power supply.
ITEM SETTINGS EXPLANATION
Language Initialize Execute Initialises the message file loaded in FLASH.
When you press the Enter button, the following
message, requesting confirmation, will appear,
Are You Sure?
Yes
No
If NO is selected, you will be returned to the source
menu.
The procedure for clearing the disk will start immediately
after the menu and rebooting.
ITEM SETTINGS EXPLANATION
To Next Page
Loading...
Need help?
General
