- 134 -
Changing Network Settings From the Web Page
5
5. Network Settings
10 Click [Submit].
The setting procedure for a certicate issued by a
certicate authority is nished.
Enabling Encryption
After creating a certicate, perform the following
procedure to enable encryption.
When you change the settings from the web
page to enable encryption, communication is
encrypted immediately after that change has
been made.
1 Perform “Creating a Certicate” P.133
steps 1 to 3 to enter the encryption
screen.
2 Select [Enable] for the desired protocol
on which encryption is applied.
3 Click [Encryption Strength Settings].
4 Select the encryption strength and click
[OK].
5 Click [Submit].
Opening the Web Page
Memo
● Ensure to enable the protocol on which encryption is
applied in “Enabling Encryption” P.134.
1 Launch a web browser.
2 Enter “https://your printer’s IP address”
in the URL address bar and then press
the <Enter> key.
IPP Printing
IPP printing allows you to transmit your print job
data from your computer to the printer via the
Internet.
Enabling IPP Printing
IPP printing is disabled by factory default. To
perform IPP printing, enable IPP rst.
1 Access the printer’s web page and log in
as the administrator.
2 Select [Admin Setup].
3 Select [Network Setup] > [IPP] >
[Settings].
4 Select [Enable] in [IPP].
5 Click [Submit].
Setting Up Your Printer As an IPP
Printer (for Windows Only)
Add the printer to your computer as an IPP
printer.
1 Click [Start] and select [Devices and
Printers] > [Add a printer].
2 On the [Add Printer] wizard, select
[Add a network, wireless or
Bluetooth printer].
3 In the list of available printers, select
[The printer that I want isn’t listed].
4 Select [Select a shared printer by
name].
5 Enter “http://your printer’s IP address/
ipp” or “http://your printer’s IP address/
ipp/lp” and then click [Next].
6 Click [Have Disk].
7 Insert the software DVD-ROM into the
computer.
8 Enter the following value in
[Copy from], and then click [Use].
- For PCL driver, “D:\Drivers\EN\PCL”.
- For PS driver, “D:\Drivers\EN\PS”.
- For XPS driver, “D:\Drivers\EN\XPS”.
Memo
● In the above examples, the DVD-ROM drive is setup
as the D drive.
9 Select the NFL le and click [Open].
10 Click [OK].
11 Select a model and click [OK].
12 Click [Next].
13 Click [Finish].
14 Print the test page after installation is
complete.