30. Test the operation of the hole punch unit:
a. With a suitable document open in a
software application, select
[File]
→
[Print].
b. Select the appropriate Oki printer, then
click [Properties].
c. Click the [Job Options] tab.
d. Under [Finisher], [Output Bin], select
[Finisher(Face-up)] or
[Finisher(Face-down)] from the drop-down
list.
e. Under [Finisher], [Staple], select
[Punch(Long-Edge)] or
[Punch(Short-Edge)], then click [OK].
f. Print the document.
31. Demonstrate how to empty the punch
collection box:
a. Push in on the finisher release lever and
slide the finisher away from the inverter.
b. Remove the punch collection box from the
finisher.
c. Empty it, then put it back into the finisher.
d. Slide the finisher back into the inverter.
Make sure it locks in place.
© 2005 Oki Data Americas, Inc. 58372901
To Previous Page
Loading...
Need help?
General
