6. Cleaning Head
Printing quality might be degraded by dust, foreign substance, adhesive substance, or other
pollution materials stuck in the printer head or inside the printer.
When dirty, clean the print head as follows:
※ CAUTION
- Make sure to turn the printer power off prior to cleaning.
- As the print head gets very hot during printing, if intending to clean the print head,
turn the printer power off and wait approximately 2~3 minute before commencement.
- When cleaning the print head, take care not to touch the heated portion of the print
head.
→ Printer Head is susceptible to damage from static electricity, etc.
- Take care not to allow the print head to become scratched and/or damaged in any way.
- Be careful not to get your fingers pinched when opening or closing the paper cover. Also
be careful the paper cover does not slip off and drop.
- When loading roll paper, be careful not to get your fingers pinched between the paper
roll and the supply unit.
- Do not touch the cutter with your hands. Doing so could result in an injury.
6-1 Cleaning Head
1) Open the Paper Cover and then use the cleaning pen to clean the head in the direction
from the center of the head to the edges.
2) After cleaning the head, do not use the printer until the alcohol used for cleaning
evaporates completely (1~2 min) and the printer has completely dried.
※ Perform the cleaning process each time the paper roll is replaced to prevent print quality
deterioration.
To Next Page
Loading...
Need help?
General
