45372301TH Rev.2
3-10 /
Oki Data CONFIDENTIAL
[A] Paper remaining jam
Any of the following:
Either of the entrance transport sensor (S1) and the exit transport sensor (S2) detects paper after
power-ON or when the jam access rear cover is closed.
When a stop notification is sent from the machine while the finisher is transporting paper.
[B] Paper not reaching entrance transport sensor
The entrance transport sensor (S1) does not detect paper after the specified period of time has passed
since a signal was received from the equipment.
[C] Stationary jam at exit transport sensor
When a specified time has passed after paper is detected by the entrance transport sensor (S1) or if
paper is not detected by the exit transport sensor (S2).
[D] Door open jam
When an open door is detected by the door switch (SW2) while the finisher is operating.
[E] Stapling jam
When the stapler is not detected in the home position by the stapler home position sensor (S11).
[F] Paper too fast jam
When paper is detected by the entrance transport sensor (S1) faster than the delay time requested by
the finisher.
[G] Malfunction jam
When a malfunction of the ejector is detected by the ejector encoder sensor (S8).
When a malfunction of the stack tray is detected by the stack home position sensor (S9).
[H] Stationary jam at exit transport sensor
When a specified time has passed after paper is detected by the exit transport sensor (S2) and the exit
transport sensor (S2) cannot detect that there is no paper.
[I] Home position detection malfunction jam
When a malfunction of the home position of the paper support is detected by the paper support home
position sensor (S6).
When a malfunction of the home position of the lever path is detected by the lever path home position
sensor (S15).
When a malfunction of the home position of the right jogger is detected by the alignment plate home
position sensor (R) (S4).
When a malfunction of the home position of the left jogger is detected by the alignment plate home
position sensor (L) (S5).
When a malfunction of the home position of the paddle is detected by the paddle home position sensor
(S3).
To Next Page
Loading...
