Scanning > 58
S
ETUP
TO
USE
THE
WSD S
CAN
The following explains how to set up the PC to use the WSD Scan function. In order to use
the WSD Scan function, install this device on the PC.
WSD Scan can be used from Scan To Local PC and Scan To Remote PC via Network.
To use WSD Scan, the machine has to be connected with the computer which Windows
Vista/ Windows7/ Windows Server 2008/ Windows Server 2008R2 was installed via
Network.
I
NSTALLATION
PROCEDURE
1. From the Start menu, select Network. The devices connected to the network are
displayed.
2. Right-click the MC362 icon under Multifunction Devices and select Install.
If the User Account Control dialog box is displayed, click Yes.
REFERENCE
Before starting the following procedure, be sure to check the network
connection. For details, see the Configuration Guide.
NOTE
If a scanner is used via WSD Scan connection and if the device IP address is
changed, select Uninstall in step 2 of Installation procedure and uninstall the
scanner, and then execute the install procedure again.
MEMO
When you follow the procedure below, the WIA is installed automatically as
the scanner driver.
NOTE
Before starting the installation, select Network and Sharing Center from
the Control
Panel and make sure that Network Search is enabled.
To Next Page
Loading...
Need help?
General
