Faxing - MC342dn, MC342dw, MC362dn, MC362w, MC562dn, MC562w, MC562dw, ES5462 MFP, ES5462dw MFP and MPS2731mc only
> 97
Broadcasting
This function allows you to send a fax to multiple recipients at the same time. By combining
abbreviation dials, groups and entering addresses using the numeric keypad, you can
specify up to 100 destinations at one time.
Deleting specified destinations
You can cancel an individual destination within a broadcast job.
1. Make sure that the required destination is selected on the fax standby screen and
then press OK.
2. Using the arrow keys, scroll to the destination you want to delete and then press
OK.
A check box is selected. You can select multiple entries.
3. When you have selected all the destinations to be deleted, press the Right arrow
key.
4. Make sure that Delete this destination is selected and then press OK.
Manual redial
Your machine is set to redial automatically (refer to “Redial Tries” on page 170), if you wish
to manually redial:
1. Press the FAX button on the control panel.
2. Press OK to select Fax.
3. Press OK to select Add Destination.
4. Using the Down arrow key, scroll to Tx History and press OK.
5. Using the arrow keys, scroll to the required destination and press OK.
The check box is selected. You can select multiple entries.
6. When you have selected all the destinations, press the Right arrow key.
7. Press OK to select Finish Destination Selection.
8. Press the Mono button (3) to start sending your document(s).
NOTE
When real time transmission (Memory Tx set to OFF) or polling is executed
during broadcasting data, they are executed preferentially. In the case of
polling, it is executed preferentially when there is only one address specified.
When Broadcast Destination is enabled, the destination numbers are
displayed before transmission. Refer to “Broadcast Destination” on page 170.
To Next Page
Loading...
Need help?
General
