Getting Started E-5
Connect to Power and Computer
3
You must supply the cable for connecting your printer
to your computer. A shielded cable is required in order
to ensure compliance of this equipment with FCC
regulations.
3
These instructions are for the standard parallel inter-
face. If you have the optional serial interface, see the
instructions included with it.
1. Make sure both the printer and the computer are off.
2. Plug the power cord into the back of the printer.
3. Plug the other end into a 120-volt, grounded outlet.
4. Plug the interface cable into the parallel port on the
back of the printer, and secure it in place with the wire
loops (
Ê
).
5. Turn the computer back on.
Ê
To Next Page
Loading...
Need help?
General