E-10 Section 1
Loading Single-Sheet Paper
The single-sheet path is best for letterhead stationery,
memos, and envelopes and is recommended for printing
graphs and charts because it provides the most accurate
control of the paper.
If you have any continuous-form paper in the
paper path, you must press the PARK button on the
front panel to remove it from the path before load-
ing single sheets.
1. Make sure the printer is turned ON and deselected
(SEL light off—press SEL button to deselect if neces-
sary).
4
The ALARM light will remain on until paper is
loaded.
2. Move the paper lever to the position marked “TOP”.
3. Grasp the back of the paper separator and unsnap it
from the housing, then swing it up into the single-sheet
feed position, making sure that the wire feed guide (
Ê
)
is nestled in the separator.
!
Ê
To Next Page
Loading...
Need help?
General