17 Configuration: Ad Hoc Mode
5. On the [General] tab, click [Change SLOT], then click
[Yes].
6. Referring to the Network Summary printout for the
wireless card (under General Information), enter the last
six digits of the Mac address as the password (minus any
punctuation), then click [OK].
7. Scroll over to the far right and click the [Wireless] tab.
8. Make your selections:
• Network Type = Ad Hoc
• Communication Mode = AUTO or 802.11b
• SSID = (name you select)
• Authentication = Open or Shared Key (WEP)
• Channel = 1 through 13 (to ensure speed and accuracy
when using wireless access points which are near each
other, be sure to leave 5 blank channels between
assigned channels; e.g., select channels 1 / 6 / 11)
• SSID = (name you select)
9. Click [Initialize].
To Next Page
Loading...
