Why is the ERROR lamp on my Oki Pos equipment lit and it's not working?
The ERROR lamp might light up and the Oki Pos equipment might fail to work due to several reasons. First, the printer could be out of paper, so make sure to set the paper. Second, the top cover may not be completely closed; ensure it is. Finally, the thermal head could be excessively hot, in which case you should wait for it to cool down.
What to do if my Oki PT330 Pos equipment printer does not print?
If your Oki Pos equipment printer isn't printing, it could be due to a disconnected or broken interface cable. Try connecting the interface cable correctly or replacing it. Another reason could be incorrect printer settings; in this case, amend the settings.
How to fix uneven printing on my Oki PT330 Pos equipment?
Uneven printing on your Oki Pos equipment can be caused by several factors. First, check the thermal head for any paper fragments or foreign matter stuck to the heating elements and clean the thermal head if necessary. Second, ensure that the printer settings are correct for the paper you are using. Third, inspect the platen roller for any foreign matter and remove it. If the issue persists, the thermal head may be damaged, requiring you to turn off the power and request repair.
Why is the print too dark or blurred on my Oki PT330?
If the print from your Oki Pos equipment is too dark or blurred, the print density setting in the printer setup may be incorrect. Try setting the printer at a suitable print density and/or print speed for the paper you are using. Alternatively, the thermal head might be damaged, requiring you to turn off the power and request repair.
Why is the print too faint on my Oki PT330 Pos equipment?
If the print from your Oki Pos equipment is too faint, the print density setting in the printer setup may be incorrect. Try setting the printer at a suitable print density and/or print speed for the paper you are using. Alternatively, the thermal head might be damaged, requiring you to turn off the power and request repair.
What to do if vertical marks appear on printout from my Oki Pos equipment?
Vertical marks on your Oki Pos equipment printouts can be due to a few reasons. It could be that foreign matter is stuck in the paper transport, so you should clean the paper transport. Another cause might be foreign matter stuck on the thermal head, so you should clean the thermal head. Finally, the thermal head could be damaged, requiring you to turn off the power and request repair.
How to troubleshoot Oki Pos equipment when the power lamp doesn't light up?
If the POWER lamp on your Oki Pos equipment's control panel doesn't light up when you turn on the power and the printer doesn't start, it could be due to a disconnected power cable. Connect the power cable. Another possible cause is that the AC adapter is not plugged in, so connect the connector of the AC adapter.
What to do if the paper is not cut in my Oki Pos equipment?
If the paper is not being cut by your Oki Pos equipment, it could be because the cutter blade is damaged or worn out, requiring you to turn off the power and request repair. Alternatively, paper fragments or other foreign matter might be stuck around the cutter or the sliding section; if so, remove the debris.
What to do if the cutter does not return to its correct position in my Oki Pos equipment?
If the cutter on your Oki Pos equipment does not return to its correct position, it is likely due to paper fragments or other foreign matter stuck around the cutter or the sliding section. Remove any such debris to resolve the issue.
General| Brand | Oki |
|---|---|
| Model | PT330 |
| Category | Pos equipment |
| Language | English |
To Next Page
