OKIDATA Microline 395 - 1.2 Product Specifications

%1.2 Product Specifications
1.2 PRODUCT SPECIFICATIONS
1.2.01 Paper Feed Method
Built-in push tractor
Friction feed
1.2.02 Paper Path
Bottom Feed
Rear Feed
Top Feed
1.2.03 Printhead Type
Staggered, 24 pin, stored energy printhead
1.2.04 Interface Methods
Both are Standard
Centronics Parallel Interface
RS232-C Serial Interface
1.2.05 Print Speed
@
cpi - Characters Per Inch
cps - Characters Per Second
1.2.06 Symbol Sets
Standard ASCII
Epson Character Set
IBM Character Set I and Set II
IBM Proprinter All Character Set
International Characters
Line Graphics
Code Page 850, 863,437
1.2.07 Standard Fonts
Utility (Used in Utility and High Speed Draft Modes)
Courier
Swiss
Roman
Orator
1.2.08 Line Feed Increments
1/6" n/180"
1/8" n/216"
n/60" n/360"
n/72"
1.2.09 Line Feed Time
55 ms @ 6 LPI
8.0 IPS (inches per second) slew rate @ gap 1,2
6.0 IPS (inches per second) slew rate @ gap 3+
1.2.10 Paper Out Detection
Printhead distance from edge of paper when End of Paper is detected
Rear Feed: 5.8"
Bottom Feed: 2.4"
ML395 ( 96-02-03 )