STEP 1
· Place the right and left rails on an even surface as shown below.
· Insert both ends of extension rail to the right and left rails as shown below and
pre-tighten the screws.
Avoid excessive tightening screws
STEP 2
STEP 3
· Mount the side brackets onto each side of the columns.
· Tighten the screws.
Left rail
Right rail
Extension rail
M6*8 screw
· Place the desk columns between the left and right rails, make sure the
screw holes on the frame and columns are aligned.
· Tighten the screws.
M5 allen key
Installation Instructions
3
M5 allen key
M6*10 screw
M5 allen key
M6*10 screw
Side bracket
Warning:
1.Control box with Gyro: please fixed it under the table board before the first use.
2.Do not use the Guide Sleeves if the frame
length needed less than 1220mm.
To Next Page
Loading...
