1.
It is necessary to be reset manually after the initial installation and power off.
Note: The Anti-Collision function is not enabled during all resets. Please note that there is a potential
risk of pinching in this case, and be sure no obstacles in the desk's path.
● Manual Reset
• Keep pressing "down" key till display shows "E-1" and "rES" alternately and
release the key.
• Keep pressing "down" key again, the desktop will move slowly down and return
back till the display shows "060" or "23.6"(Depends on your version of the
control box).
2.
• Release the key , the height-adjustable desk can be used normally.
3.
● Saving position
3.
● Up and Down
1. • Keep pressing "up" key till the required height is reached.
2. • Keep pressing "
down" key till the required height is reached.
rES
060
• Adjust the desktop to the height you want to save.
• Keep pressing "S" key till the display will show "S - -".
• Press "1" key, the display will show "S-1" and the current height alternately.
• Press "S" key, the first memory position is set successfully. Similar procedure
for "2" key and "3" key memory positions.
4.
S
1.
2.
By using memory function, the desktop can easily be programmed to preferred height positions.
S
▲
1
3
2
S
▲
5
Instruction
To Next Page
Loading...