OKP K 8 - Boundary Strip Usage Notes

19
2 . Operating and Programming / 2. 7 Use the Boundary Strip
With the Boundary Strip, you can keep Robot away from any area or item you do not want Robot to clean.
Robot will recognize the Boundary Strip and will not cross into the blocked- off area.
1. Identify the area or item you do not want Robot to get close to.
2. If necessary, use scissors to cut the Boundary Strip to a shorter length. Be sure to correctly measure the length before cutting.
3. Apply the supplied strips of adhesive tape to lay the Boundary Strip flat on the floor.
Make sure the strip is placed FLAT on the floor or under an area rug.
Notes:
- If the Boundary Strip is rolled up, remove and then re- apply on the fl oor with
adhesive tape. Otherwise the Boundary Strip may not work well.
- Make sure the Boundary Strip is placed on the same surface plane Robot is
used on.
- Be careful not to damage the floor when using adhesive tape. It is not
recommended for use on carpets.
- Keep the Boundary Strip away from objects that emit excessive heat.