FWD
(2):
Press this button to advance quickly to
another part
of
the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during
FWD
operation by using TUNE.
PROG
(3):
Press this button to play the other side
of
the tape.
00
(4):
Press this button to reduce background noise.
Note that the double-D symbol will appear on the display.
Dolby@ Noise Reduction is manufactured under a
license from Dolby Laboratories Licensing Corporation.
Dolby and the double-D symbol are trademarks of
Dolby Laboratories Licensing Corporation.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds of silence between each
selection for
SEEK
to work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will mute
while scanning, SCAN will appear on the display and
the tape direction arrow will blink while scanning.
AM-FM:
Press this button to play the radio when a tape
is in the player. The tape will stop but remain in the player.
TAPE-CD:
Press this button if you have a disc loaded
in
the changer and the radio is playing, to play a
compact disc. Press
AM-FM
to return to the radio when
a
compact disc
is
playing. Press TAPE-CD to switch
between the tape and compact disc if both are loaded.
The inactive tape or CD will remain safely inside the
radio for future listening.
EJECT
Press this button to remove the tape. The radio
will play. EJECT may be activated with either the
ignition or radio off. Cassettes may be loaded with the
radio and ignition off
if
this button is pressed first.
If
you leave a cassette tape in the player while listening to
the radio, it may become warm.
CLN:
If this message appears on the display, the
cassette tape player needs
to
be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player”
in
the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was
reset.
3-20
To Next Page
Loading...
Need help?
General
