Playing
a
Compact
Disc
The CD player will play either normal-size discs or the
smaller
8
cm discs with an adapter.
With the ignition on, insert a disc partway into the slot,
label side up. The player will pull it in and the disc
should begin playing.
Note that when the disc is inserted, CD will be
displayed. When the disc is playing, a box will appear
around CD on the display. If you select a tone setting for
your CD,
it
will be activated each time you play a CD.
As
each new track starts to play, the track number will
appear in the display.
If you’re driving on a very rough road or if it’s very hot,
the disc may not play and
E
(error) and a number may
appear on the radio display. If the disc comes out, it
could be that:
The disc is upside down.
It is dirty, scratched or wet.
The air is very humid.
(If
so,
wait about an hour and
try again.)
If
any error occurs repeatedly or if an error can’t be
corrected, please contact your retailer. If your radio
displays an error number, write it down and provide it to
your retailer when reporting the problem.
REV
(1):
Press and hold this button
to
quickly reverse
within a track. You will hear sound at a reduced volume.
The display will show elapsed time.
FWD
(2):
Press and hold this button to quickly advance
within a track. You will hear sound at a reduced volume.
The display will show elapsed time.
RDM
(5):
Press this button to hear the tracks in random,
rather than sequential, order. RDM will appear on the
display when
you
press this button. Press RDM again to
turn
off
random play.
SEEK:
Press the down arrow to go to the start
of
the
current track
if
more than eight seconds have played.
Press
the
up arrow to go to the next track.
If
you hold
the button or press it more than once, the player will
continue moving rearward or forward through the disc.
SCAN:
Press this button to listen to each selection for a
few seconds. The disc will go to the next selection, stop
for
a
few seconds, then go on to
the
next selection. Press
this
button again to stop scanning. The sound will mute
while scanning,
SCAN
will appear on the display and
the disc direction arrow will blink while scanning.
3-21
To Next Page
Loading...
Need help?
General
