If
you
prefer to program the exit seat position, which
moves the seat completely down and back, follow
these steps:
1.
Press the
SET
button on the driver’s door panel. You
will hear one beep.
2.
Press one of the memory buttons on the driver’s door
panel.
You
will hear one beep, but the seat will not
move at this time.
3.
Press the UNLOCK button on the appropriate
transmitter within five seconds. You will hear
two beeps.
This
personalization feature will work only when the
vehicle is in PARK
(P).
A beep will sound inside the
vehicle when the UNLOCK button on the transmitter is
pressed to move the seat and mirrors.
To
turn this feature off, pr.ess
SET
and then UNLOCK
within five seconds.
Delayed
Locking
This Personalization feature lets the driver delay the
actual
locking
of
the vehicle. When the power door lock
switch is pressed, with the key removed
from
the
ignition and the driver’s door open, a chime will sound
three times to signal that the lock delay mode is active.
When all doors have been closed, the doors will lock
automatically after five seconds. If any door is opened
before this, the five-second timer will reset itself once
all the doors have been closed again.
Pressing the door lock switch twice within two seconds
will override this feature.
The delayed locking feature can be turned on or
off
for
each remote transmitter.
To
turn the feature on:
1.
Press and hold the power door lock switch
throughout this procedure. All the doors will lock.
2.
Press the UNLOCK button on the remote transmitter.
The lock delay is still
off
and
all
doors will remain locked.
3.
Press the UNLOCK button on the remote transmitter
again. Lock delay is now active and
all
doors will unlock.
4.
Release the power door lock switch.
To
turn
the feature off, repeat the previous procedure.
2-12
To Next Page
Loading...
Need help?
General
