AM-FM Stereo with Cassette Tape and
Compact Disc Player with Automatic Tone
Control
(If
Equipped)
Playing the Radio
PWR-VOL:
Press this knob to turn the system on and
off. To increase volume, turn the knob to the right. Turn
it to the left to decrease volume.
\
RCL:
Press
this button briefly to recall the station being
played or to display the clock.
To
change what is
normally shown on the display (station or time), press
the RCL button until you see the display you want, then
hold the RCL button until the display flashes.
If
you
press the button when the ignition
is
off,
the clock will
show for a few seconds.
Finding a Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press this knob lightly
so
it extends. Turn
it
to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow to go to the next
higher
or
lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release it to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then go on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning,
and
SCAN will appear on the
display. If you press SCAN for more than two seconds,
the radio will change to P SCAN mode. P
SCAN
will
appear on the display.
To Next Page
Loading...
