FWD
(2):
Press
this
button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances. You may select stations
during
FWD
operation by using
TUNE.
PROG
(3):
Press this button to play the other side of
the tape.
00
(4):
Press this button to reduce background noise.
Note that the double-D symbol will appear
on
the
display.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing
a cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds of silence between each
selection for
SEEK
to work.
SCAN:
Press
this
button to listen to each selection for a
few seconds. The tape
will
go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound
will
mute,
SCAN
will
appear on the display and the tape direction
arrow will blink while scanning.
AM-FM:
Press
this
button to play the radio when a
tape is in the player. The tape will stop but remain
in
the player.
TAPE
AUX:
If
you have a tape inserted and the radio is
playing, press TAPE AUX to play your tape.
To
return
to the radio while a tape is playing, press AM-FM. The
inactive tape
will
remain safely inside the radio for
future listening.
EJECT:
Press this button to remove the tape. The
radio will play.
EJECT
may
be
activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition
off if
this button is pressed first.
CLN:
If
this message appears on the display, the
cassette tape player needs to be cleaned. It
will
still play
tapes, but you should clean it
as
soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
3-12
To Next Page
Loading...
