AM-FM Stereo with Cassette Tape and
Compact Disc Player with Automatic Tone
Control
(If
Equipped)
Playing the Radio
PVVR-VOL:
Press this knob to turn the system on and
off.
To increase volume, turn the knob to the right. Turn
it
to the left to decrease volume.
RCL:
Press
this
button briefly to recall the station
being played or to display the clock. To change what is
normally shown on the display (station or time), press
the RCL button until you see the display you want, then
hold the RCL button until the display flashes.
If
you
press the button when the ignition
is
off,
the clock will
show for a few seconds.
Finding a Station
AM-FM:
Press this button to switch between
AM,
FM1
and
FM2.
The display shows your selection.
TUNE:
Press
this
knob lightly
so
it extends. Turn it to
choose radio stations. Push the knob back into its stored
position when you’re not using it.
SEEK:
Press the up or down arrow to go
to
the next
higher or lower station and stay there. The sound will
mute while seeking.
SCAN:
Press this button and release it to listen to
stations for a few seconds. The radio will go to a station,
stop for a few seconds, then go on to the next station.
Press the button again to stop scanning. The sound will
mute while scanning, and
SCAN
will appear
on
the
display.
If
you press
SCAN
for more than two seconds,
the radio
will
change to
P
SCAN
mode.
P
SCAN
will
appear on the display.
3-13
To Next Page
Loading...
