PUSHBUTTONS:
The five numbered pushbuttons let
you return to your favorite stations. You can set up to
15
stations (five
AM,
five
FM1
and five
FM2).
Just:
1.
Turn the radio on.
2.
Press AM-FM to select the band.
3.
Tune in the desired station.
4.
Press TONE to select the equalization that best suits
the type of station selected.
5.
Press and hold one of the five numbered buttons.
The sound will mute. When it returns, release the
button. Whenever you press that numbered button,
the station you set will return and the tone that
you selected will also be automatically selected
for that button.
6.
Repeat the steps for each pushbutton.
P
SCAN:
Press SCAN for more than two seconds, and
P SCAN will appear on the display. The radio will go to
the first preset station stored on your pushbuttons, stop
for a few seconds, then go on to the next preset station.
Press SCAN again to stop scanning.
Setting
the
Tone
BASS:
Press
this knob lightly
so
it extends. Turn the
knob to increase or decrease bass. When you use
this
control, the radio’s tone setting will switch to manual.
TREB:
Press this knob lightly
so
it extends. Then pull
the knob
all
the way out. Turn the knob to increase or
decrease treble. When you use this control, the radio’s
tone setting will switch to manual.
If
a station is weak
or noisy, you may want to decrease the treble.
Push
these knobs back into their stored positions when
you’re not using them.
TONE:
This
feature allows you to choose preset bass
and treble equalization settings designed for jazz, vocal,
pop, rock and classical stations.
JAZZ
will appear on the
display when you first press TONE. Each time you press
it, another setting
will
appear on the display. Press it
again after CLASSIC appears and
MANUAL
will
appear. Tone control will return to the BASS and TREB
knobs. Also,
if
you use the BASS and TREB knobs,
control will return to them and MANUAL will appear.
3-14
To Next Page
Loading...
