FWD
(2):
Press
this
button to advance quickly to
another part of the tape. Press the button again to return
to playing speed. The radio will play the last-selected
station while the tape advances.
You
may select stations
during
FWD
operation by using
TUNE.
PROG
(3):
Press this button
to
play the other side
of
the tape.
00
(4):
Press this button to reduce background
noise. Note that the double-D symbol will appear
on the display.
Dolby Noise Reduction is manufactured under a license
from Dolby Laboratories Licensing Corporation. Dolby
and the double-D symbol are trademarks of Dolby
Laboratories Licensing Corporation.
TONE:
Press this button to select a tone while playing a
cassette. The tone will be automatically set whenever
you play a cassette tape.
SEEK:
Press the up or down arrow to search for the
next or previous selection on the tape. Your tape must
have at least three seconds
of
silence between each
selection for SEEK to work.
SCAN:
Press this button to listen to each selection for a
few seconds. The tape will go to the next selection, stop
for a few seconds, then go on to the next selection. Press
this button again to stop scanning. The sound will mute
while scanning,
SCAN
will appear
on
the display and
the tape direction arrow will blink while scanning.
AM-FM:
Press this button
to
play the radio when a
tape is in the player. The tape will stop but remain in
the player.
TAPE-CD:
Press
this
button
if
you have a disc loaded
in
the CD player and the radio is playing, to play a compact
disc. Press
AM-FM
to return to the radio when a compact
disc is playing. Press TAPE-CD to switch between the
tape and compact disc if both
are
loaded. The inactive
tape or CD will remain safely inside the radio for future
listening. The display
will
show
TP
and CD.
EJECT:
Press
this
button to remove the tape. The
radio will play. EJECT may be activated with either the
ignition or radio
off.
Cassettes may be loaded with the
radio and ignition
off
if
this
button is pressed first.
CLN:
If
this
message appears on the display, the
cassette tape player needs to be cleaned. It will still play
tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care
of
Your Cassette Tape Player” in the Index. After you clean
the player, press and hold EJECT for five seconds to
reset the CLN indicator. The radio will display
---
to
show the indicator was reset.
3-16
To Next Page
Loading...
