Playing a Compact
Disc
With the ignition on, insert a disc partway into the slot,
label side up. The player will pull it
in
and the disc
should begin playing.
If
you want to insert a CD when
the ignition is
off,
first press EJECT or RCL.
The CD player will play either normal-size discs or
the smaller
8
cm discs with an adapter.
Note that when the disc
is
inserted, CD will be
displayed. When the disc is playing, a box will appear
around CD on the display.
If
you select a tone setting for
your CD, it will be activated each time you play a CD.
As
each new track starts to play, the track number will
appear in the display.
If E (error) and a number appear on the radio display
and the disc comes out, it could be that:
0
E20:
The road is too rough. The disc should play
E20:
The disc is
duly,
scratched, wet or upside
0
E20:
The air is very humid.
If
so,
wait about an hour
If
any error occurs repeatedly or if an error can’t be
corrected, please contact your retailer.
If
your radio
when the road is smoother.
down.
and try again.
displays
an
error number, write it down and provide it to
your retailer when reporting the problem.
REV
(1):
Press and hold this button
to
quickly reverse
within a track. You will hear sound at a reduced volume.
The display will show elapsed time.
FWD
(2):
Press and hold this button to quickly advance
within a track. You will hear sound at a reduced volume.
The display will show elapsed time.
RDM
(5):
Press this button to hear the tracks in random,
rather than sequential, order.
RDM
will appear on the
display when you press this button.
TONE:
Press this button to select a tone while playing a
compact disc. The tone will be automatically set
whenever you play a compact disc.
SEEK:
Press the down arrow to go to the start of the
current track if more than eight seconds have played.
Press the up arrow
to
go to the next track.
If
you hold
the button or press it more than once, the player
will
continue moving rearward or forward through the disc.
SCAN:
Press this button to listen to each selection for a
few seconds. The disc will go
to
the next selection, stop
for a few seconds, then go on to the next selection. Press
this
button again to stop scanning. The sound will mute
while scanning, SCAN will appear on the display.
3-17
To Next Page
Loading...
