Playing a Disc
To play a disc, gently insert the disc with the label side
up into the loading slot. The DVD player will continue
loading the disc and the player will automatically start.
If a disc is already in the player, press the play/pause
button on the face of the player or on the remote control.
Some DVDs will not allow you
to
fast forward or skip
the copyright or previews. Some DVDs will begin playing
after the previews have finished. If the DVD does not
begin playing, refer
to the on-screen instructions.
Stopping and Resume Playback
To stop a disc, press and release the stop/eject button
on the DVD player or the stop button on the remote.
To resume playback, press the play/pause button on the
DVD player or the remote. As long
as
the disc has
not
been ejected and the stop button has not been
pressed twice on the remote control, the movie should
resume play from where it was last stopped. If the
disc has been ejected or
if
the stop button on the remote
has been pressed twice, the disc will resume play at
the beginning.
Parental Control Button:
This button is located on the
front of the DVD console which is mounted vertically
above the driver’s right shoulder. Press this button while
a DVD is playing to freeze the video and mute the
audio
to
the headphones.
It
will also disable all other
button operations from the remote and DVD player. The
driver will then be able to gain the attention of the rear
seat passengers. Press this button again
to
restore
normal play of the DVD.
Ejecting a Disc
Press the stop/eject button on the DVD player once to
stop and a second time
to
eject the disc.
If
a
disc is ejected from the player, but not removed, the
DVD player will reload the disc after approximately
10
to
20
seconds.
DVD Messages
The following errors may be displayed:
8
8
Disc Format Error:
This message will be displayed
if
a disc is inserted upside down,
if
the disc is not
able to be read or
if
the disc format is not
compatible.
Disc Play Error:
This message
will
be displayed
if
the mechanism can not play the disc. Severely
scratched discs
will
cause this error.
Region Code Error:
This message will be
displayed for all non Region
1
discs (DVDs sold
outside of North America).
Load/Eject Error:
This message will be displayed
if
the disc is not properly lined up in the mechanism.
Disc Not Present:
This message will be displayed
if
the
PLAY,
EJECT or DVD AUX buttons are
pressed and no disc is in the player.
3-80
To Next Page
Loading...
