Page 19
DIFFERENTIAL PRESSURE TRANSMITTER - USER GUIDE
4. SAFETY, CERTIFICATIONS, COMPLIANCE
1. Safety
CAUTION: Ensure installation of the transmitter meets applicable state and
National Electrical Code requirements. The installation of the transmitter
should only be performed by a qualified installer or a factory
representative.
WARNING: The pressure transmitter is powered by an external power
supply. The power supply circuit must comply with energy-limiting circuit
by relevant standards and pay attention to the high voltage circuits that
may exist.
WARNING: Do not exceed the maximum static pressure rating of the
sensor.
WARNING: Using the pressure transmitter in hazardous areas, installation,
use and maintenance must also comply with the operation manual and
relevant requirements of national standards.
WARNING: Disassemble the pressure transmitter only at normal
atmospheric pressure.
WARNING: EXPLOSION HAZARD – THIS DEVICE SHALL BE REMOVED
FROM THE AREA KNOWN TO BE HAZARDOUS IF MAINTENANCE IS
REQUIRED.
WARNING: To prevent static discharge, wipe with damp cloth only.
WARNING: Although the transmitter is very durable, do not install it on
high vibration applications or where transmitter is subject to severe
mechanical shock.
WARNING: If the equipment is used in a manner not specified by
OleumTech, the protection provided by the equipment may be impaired.
WARNING: Safety of any system incorporating the transmitter is the
responsibility of the assembler of the system.
WARNING: Do not open when an explosive atmosphere is present.
WARNING: A seal shall be installed withing 50 mm of the enclosure.
To Next Page
Loading...