EasyManua.ls Logo

Olimpia splendid ARYAL S1 E - Manual Operation; Maintenance and Cleaning

Olimpia splendid ARYAL S1 E
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ARYAL S1 E
ENGLISH
EN - 33
TIMERON>TIMEROFF(gures“33”,“34”and“40”)
(On => Stop => Start functioning)
This function is useful if the air conditioner is to be switched on before getting up and switched off after
leaving home.
Example:
The time is 20:00. If the air conditioner is to be switched on at 06:00 the next morning and switched of at 08:00.
a. Press the “TIMER ON” key (7) to display “TIMER ON”.
thetimeashes.
b. Press the “TEMP” keys (4) until the value “10:00” is set near to the “TIMER ON” indicator.
c. Press the “TIMER OFF” key (8) to display “TIMER OFF”.
thetimeashes.
d. Press the “TEMP” keys (4) until the value “12:00” is set near to the “TIMER OFF” indicator.
e. Wait3seconds,thetimesetwillstopashingandthefunctionwillbeactive.
3.8 - MANUAL OPERATION (gures41and42)
Manual operation can be used temporarily if the remote control cannot be found or its batteries are discharged.
a. Openandliftthefrontpaneltoanangleinwhichitblocksanda“click”isheard(gure41).
b. Pressthecontrolkeyonce(AUTO/COOL)tostartoperationin“AUTO”mode(gure42).
c. Closethepanelwell,takingitbacktoitsoriginalposition(gure46).
Bypressingthemanualkey,theoperatingpassesinsequenceto:
AUTO > COOL > OFF.
Pressthekeytwicetostarttheunitinforced“COOL”mode.
This mode must be used for the inspection only.
By pressing the key a third time. operation stops and the air conditioner switches off.
To restore remote control operation, use the remote control directly.
4 - MAINTENANCE AND CLEANING
Before proceeding with any maintenance and cleaning, always make sure the sys-
tem has been switched off, using the remote control, and the power supply plug
has been disconnected from the system socket (or the upstream master isolating
switchispositionedat“0”OFF).
Donottouchthemetalpartsoftheunitwhenremovingtheairlters.
They are very sharp. Cuts or injury risk.

Table of Contents

Related product manuals