Olimpia splendid UNICO NEXT - Maintenance

min.80mm
41
39
42
40
3
F
F
F
F2
F2
F2
F1
F1
F1
F1
F2
B
A
EN - 44
ENGLISH
a. Electrically disconnect the appliance.
b. Switch off the unit and wait for the closure of the suction ap.
c. Manually raise the air suction grille (3) (g. 39).
d. Raise the front part of the lter (F) and slightly pull it towards yourself (g. 39).
e. Extract the two additional lters (g. 40) from the lter group (F):
(green purifying lter ref. F1 - black active carbons lter ref. F2).
f. Perfectly wash and dry all the lters.
Filter reassembly:
g. Insert the active carbon lter (black colour) (ref. F2) on the pins located on the
front part of the lter (F) (g.41b).
h. Insert the purifying lter (green colour) (ref. F1) on the pins located on the front
part of the lter (F) (g. 41b).
i. Reassemble the lters group (F1-F2) inserting the rear edge inside the grid (g.
42).
l. Manually close the air suction grille (3).
To cancel the dirtylterreport, after having connected the air conditioner to the mains
voltage, press simultaneously, for at least 5 seconds, the keys Stand-by and MODE
located on the command panel (Fig.30). This way, the dirty lter report is cancelled
and the respective counting is reset.
5.2 - MAINTENANCE