Olimpia splendid UNICO NEXT - Choosing the Position of the Unit

UNICO NEXT R290
min 60mm
min
80mm
min 60mm
min
100mm
2
EN - 15
ENGLISH
• For particularly important applications, we recommend contacting expert heating
engineers.
• The user should try to limit high heat loads as much as possible as follows:
glass doors and windows exposed to many hours of sunlight should be tted on
the inside with curtains or, even better, on the outside with coverings such as
Venetian blinds, verandahs, refractive lm, etc.). The air-conditioned room must
remain closed as long as possible.
• Halogen spotlights or other electrical equipment with high power consumption
should not be used in the room (toasters, steam irons, hot plates for cooking,
etc.).
2.3 - CHOOSING THE POSITION OF THE UNIT
To obtain the best operating performance and prevent faults or hazardous conditions,
the position of indoor unit installation must meet the following requirements:
a. Do not expose the appliance to heat or steam sources (g. 3).
b. Make sure that the space to the right and left is at least 60 mm and space above
the unit is at least 80 mm. (g. 2).
c. The height of the unit’s lower edge from the oor should be at least 100 mm if
xed to the wall in the lowest position. If xed to the wall in the highest position,
it should be at least 80 mm from the ceiling (g. 2).
d. The wall where the indoor unit is to be xed, must be stable, strong and suitable
to support the weight.
e. It must be possible to leave room around the unit for any maintenance operations
that may be necessary.