Olimpia splendid UNICO NEXT - Input Setting Configuration; Temperature Unit of Measurement Configuration; Heat Pump; Only Cooling; Only Heating Configuration

28 29
8a
X1
Y3
Y2
Y1
EN - 28
ENGLISH
Values >0 increase the Tset in heating, increasing machine power (for instance, if
Tset=24°C and Energy boost = 3°C, the machine works if the Tset is 27°C)
To congure the appliance at the activation of one of the two functions, proceed as
follows:
a. Undo the screws (3a) and (1b) and remove the cover (6) of the appliance (g.
25).
b. Undo the six xing screws (X1).
c. Remove the switchgear cover (3a) (g. 28).
d. From the screw clamp (Y2), remove the supplied bridge (Y3) (g. 29).
e. Close the cover of the switchgear (3a) through the six screws (X1).
f. Reassemble the front cover of the machine.
The inlet must be driven by a potential-free contact.
Do not use a cable longer than meters 10.
2.6.3-Inputsettingconguration
In the conguration of the open or closed contact, the display shows .
To set the desired conguration, carry out the previously described procedures and
choose between the parameter
(closed contact) or (open contact).
2.6.4-Temperatureunitofmeasurementconguration
In the conguration of the unit of measurement of temperature, the display shows .
To set the desired conguration, carry out the previously described procedures and
choose between the parameter
(metric system) or (imperial system).
2.6.5-Heatpump/onlycooling/onlyheatingconguration
During conguration of the mode of operation of the unit, the display shows .
To set the machine so as that it works both in cooling and in heating mode, select the
“HP” conguration (heat pump).
To set the machine so as that it works in cooling mode only, select the “CO” cong-
uration (cooling only).