Oliver 1308-C - Power Connection and Pre-Operation Checks

1308S20034 3 - 3
 Hold down on the handle
and remove the strap
 Lift Handle
 Handle shown in the
upright position
 Install power cord plug
as shown
 Plug power cord in 115V
wall socket
 With handle in the upright
position push in on the rocker switch to the “I” position (POWER ON)
 Allow 30 minutes for the
heater platen to heat up to temperature
 Install tray carrier  Step One
 Using the locating pins in
the tray carrier and holes in the frame as shown