MODEL 702-N, 702-NSE and 702-NSS BUN SLICERS
0702S20036
OPERATING INSTRUCTIONS
After adjustments for product width and bottom slice height have been made, (see
adjustment section), you are ready to begin slicing your product.
Start the motor by turning the switch to the "ON" position, then place the product on the
chute and allow it to slide into the blade, (do not throw the product into the machine). If
the buns resist sliding freely into the blade simply use one or more additional buns to
advance the first into slicing position.
WARNING
NEVER STICK YOUR HAND OR ANY OTHER OBJECT INTO EITHER
END OF THE CHUTE. KEEP YOUR HANDS AWAY FROM THE MOVING
PARTS OF THE MACHINE.
CAUTION
NEVER PLACE A PRODUCT IN THE MACHINE BEFORE STARTING THE
MOTOR. THIS MAY PREVENT THE KNIFE FROM ROTATING AND
CAUSE MOTOR DAMAGE.
On Model 702-N machines, should the sliced bun stop under the discharge door, the
next bun through the blade will generally dislodge it. If this does not happen, re-adjust
the slow down door or inside guide, see adjustment section of this manual.
To Next Page
Loading...
Need help?
General
